"Ask Me Anything:10 Responses To Your Questions About Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 might be a little old, but it is still appealing. It's not the most luxurious vehicle in its class, but it's an enjoyable and comfortable driving experience.

We often receive requests from Coded Car Keys to replace peugeot key (click for more info) fobs. The following suggestions will help whether the problem is intermittent, or constant.

Water Damage

If you leave your fob in a puddle or get it wet during kayaking, swimming, canoeing, rafting or canyoning, it's more likely to suffer water damage. The best way to avoid this from happening is to keep it in a dry, dry bag when you're outdoors or performing activities in which the fob may be exposed to excessive amounts of water.

You'll also need to make sure that the fob is dry before opening it up and re-using it. If you notice any smells emanating from the fob (such as industrial fluid or windshield washer fluid) It's another sign that it has been submerged.

A circuit board that's damp can cause the battery to lose its charge or even explode. If you're able fish your 308 key fob out from the body of water it got stuck in turn the button upside down and shake out as much water as you can before opening the case. Take the battery out, and then wipe the circuit board clean with a cotton swab, which is dipped in 90 percent alcohol.

Other reasons your Peugeot 308 remote entry keyless system might not function include a dead coin-cell battery or receiver module issues signal interference or a faulty chip. If none of these is the problem, you can try resetting your system by disconnecting the 12 volt battery for about 15 minutes.

Dead Coin Battery

peugeot partner key fob programming cars are equipped with remote start technology that allows drivers to start their car from an extended distance, which allows them to warm up or cool down the car before entering. This feature is extremely useful, especially during cold winter months. The remote start system may stop working for a variety reasons, such as the dead battery in the coin-battery.

The coin-shaped battery contained within the key fob may last between two and four years, based on how often it is used, where it was purchased, and the way it is used. The date of use is usually written on the package or listed in the instruction manual.

If the key fob is no longer working after being exposed pure tapwater, you need to remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing. If the key fob was exposed to salty or soapy water, it may have caused the chip to become damaged. It is necessary to replace it.

If you're unsure if the battery is defective You can test its voltage using a multimeter attached to both the plus and minus terminals. The voltage should be around 12 to 13 volts, however, if it reads lower, the battery must be replaced. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should be able to start after this.

Faulty Receiver Module

If you aren't seeing the "Key Detected", it could be the receiver module faulty. It's the component that sends an alarm to the car when your key fob is activated it also acts as an immobiliser and prevents it from starting unless the correct key is in place.

This could be caused by several factors, including water damage or just the aging process. If the electronic chip in your Peugeot 308 keyfob has been damaged due to dirty tap water it could be due to the fact that the keyfob was in contact with it. In this scenario you'll need to remove off the battery and clean it thoroughly using isopropyl alcohol or electronic cleaner. Once it's dry, you can put the battery back in and test it again.

If the issue is not resolved, it is recommended that you visit a local Peugeot expert or locksmith. They'll utilize a diagnostic tool to identify the issue and repair it for you.

It can be stressful to lose your Peugeot car key. A professional auto locksmith can solve the issue in minutes. They can program your car and cut a new, functioning key for you. Find a locksmith in your area.

Faulty electronic chip

The electronic chip inside the peugeot boxer van replacement key 308 key fob plays a vital function in the remote control system. If it becomes damaged, your car may not start or receive a message saying "anti-theft active". In this case the only option is to replace the key. Auto locksmiths who are professionals are able to provide this fastest possible time.

The chip in your Peugeot 308's key fob may fail due to different reasons, including sweat, water damage or dirt. If your peugeot van key replacement 308 key fob has been exposed to soapy water, clean it immediately. You can make use of a paper towel and isopropyl alcohol for cleaning the electronic component. Then, you need to let the battery dry completely.

Radio interference can cause a key fob to stop functioning. This is usually caused by other devices operate on the same frequencies as your peugeot 107 key keyfob. It can also be caused by weather conditions or objects around the vehicle. If you experience this issue it is recommended to visit an Peugeot dealership.

The Peugeot 207/308 key fob is very delicate and requires special attention. You shouldn't drop it or throw it around. If you lose something, try to find it as soon as you can. You can reset the onboard computer by disconnecting the battery for a couple of minutes. Make sure you disconnect the negative first, and then the positive.